We are upgrading our Sonic Mainnet infrastructure to v2.2.7 on 2026-11-25. This release fixes critical RPC and tracing method behavior discrepancies where simulation and trace results diverged from actual on-chain execution, including gas accounting, code size limits, log indexing, and crash conditions. Brief interruptions to RPC availability may occur on that date.
RPC Changes:
- eth_simulateV1 uses Sonic’s code size limits: 48 KiB for code, and 96 KiB init code for creation transactions. - eth_simulateV1 fails value transfers that exceed the sender’s balance instead of returning a request error. - eth_simulateV1 ends a transaction after each call, so later calls no longer see transient storage, refunds or EIP-6780 status left by earlier calls. - eth_simulateV1 only checks nonces when validation: true is set. - eth_simulateV1 no longer returns logs or Transfer entries from failed call frames or CALLCODE. - eth_simulateV1 numbers logIndex sequentially across the block. - eth_simulateV1 no longer crashes when blobVersionedHashes is set without maxFeePerBlobGas. - eth_simulateV1 reports a gasUsed that matches the on-chain receipt. Calls that omit gas default to the remaining block gas, and gasUsed adds 10% of unused gas. If you use gasUsed as an estimate, set gas explicitly. - eth_call, eth_estimateGas and eth_simulateV1 default the blob fee cap to 0 when maxFeePerBlobGas is omitted. - eth_createAccessList, eth_sendTransaction, eth_signTransaction and eth_fillTransaction count calldata correctly when it is sent as input. eth_createAccessList also no longer fails with “intrinsic gas too low” when gas is omitted. - trace_call and trace_callMany report correct stateDiff for accounts that self-destruct, receive value, or are created and destroyed in the same transaction. Unchanged accounts and storage slots are omitted. - trace_filter’s fromAddress/toAddress filters match CREATE, CREATE2 and SELFDESTRUCT traces. Using after without count now returns results. - callTracer reports correct log indices instead of 0x0 for every log. - debug_trace* and trace_* show CREATE/CREATE2 calls with 48–96 KiB init code as failed, matching on-chain results.